Keep Your Pipes From Freezing This Winter

prevent frozen pipes in texas

After last year’s unexpected freeze, many Texans are understanding the true devastation of frozen pipes. When the phones were ringing, we at Daniel’s did our best to answer the call, but couldn’t keep up with demand, as many other plumbing companies in Austin faced the same dilemmas. 

While the temperatures don’t drop that dramatically that often here in Texas, your local Austin plumbers are here to give you that ounce of prevention to turn into a pound of cure. Below are some of the top ways to protect your pipes from freezing (and bursting) this winter in Austin. 

Keep The Heat On…At Least a Little

You don’t have to turn your heat all the way up for it to help keep your pipes thawed. Try setting your thermostat to at least 50 degrees even when you’re out of town. This helps reduce your energy usage but keeps your home warm enough that pipes shouldn’t freeze. Note that you may still need to take extra precautions with pipes that run along an outside wall or that are in an uninsulated space. 

Let it Drip

If there’s a pipe that you’re especially worried about, turn on that faucet that the pipe feeds and let it drip. This alleviates the pressure. Even if the pipe does freeze, the water is less likely to build up inside and cause it to burst. Then you can thaw the pipe without risking damage to your home. 

Open (Doors) Wide

If you’re concerned about pipes that are located inside cabinets, open the cabinet doors to optimize airflow. That way, more of the heated air in the room will end up in the cabinet. This may not seem like it would help much, but it can make a huge difference!

Seal it Up

If there are cracks or holes where pipes run through walls (especially from inside to outside), seal these up. Use caulk to fill them in or try spray foam for larger openings. Whenever possible, seal from both the inside and the outside. All of this sealing keeps cold air from outside from getting in and freezing your pipes.

Try Heating Tape

Wrap pipes that tend to freeze in heating tape. Try to find tape that turns on when it senses that heat is needed, then turns off again when things warm out. Another kind of tape stays on all the time and must be plugged in. This can be a fire hazard and is usually used to thaw frozen pipes, not keep pipes from freezing in the first place. 

Insulate, Insulate, Insulate!

Add insulation to areas where you have a lot of pipes. Think particularly about basements, attics, and garages. These areas tend to be colder than the rest of the house and may not be properly insulated to protect pipes. You can either insulate the entire space or put insulating sleeves on the pipes to protect them. Either way, keep as much heat on those pipes as possible. 

Contact us at Daniel’s Austin if you have concerns about your pipes, need some help protecting them this winter, or if you end up with a pipe that bursts. We’ll be there soon to help you out!

Air Conditioning / Refrigeration Contractor License:
#TACLB00066171E
Master Plumber License: #37341
Terms and Conditions | Privacy Policy
©2022 Daniel's Plumbing and Air Conditioning All Rights Reserved